 |
| The leftovers |
 |
| Clean cut |
Then I shaped the first piece for the lower driver's side. It only involved one bend ... the bottom lip. Once it was shaped I fit and welded it on.
 |
| Outiside |
 |
| Inside |
Sunday, August 28, 2011
August 28 2011: The Bed day 3
Today I marked the length of the sides again, using 59 inches as a guide. 59 was the maximum length I could go to even up both sides.
Then I shaped the first piece for the lower driver's side. It only involved one bend ... the bottom lip. Once it was shaped I fit and welded it on.
Then I shaped the first piece for the lower driver's side. It only involved one bend ... the bottom lip. Once it was shaped I fit and welded it on.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment